Tanaka TCS 40EA Instructions De Sécurité Et Mode D'emploi page 10

English
Chain oil (Fig. 11)
Slowly open the oil tank (16), and fi ll up with chain oil.
Always use good quality chain oil. When the engine
is running, the chain oil is automatically discharged.
Fill up the oil tank (16) with chain oil every time when
refueling.
NOTE
When pouring fuel or chain oil into the tank,
place the unit with cap side up. (Fig. 11)
Adjustment of chain oil supply
The chain oil quantity discharged through the
lubrication system is factory adjusted to the
maximum. Adjust the quantity in accordance with
the operating condition.
Turn the adjusting screw (17) counterclockwise
to increase the quantity and turn it clockwise to
decrease the quantity. (Fig. 12)
Starting the cold engine (Fig. 13-18)
CAUTION
Before starting, make sure that the bar/chain
does not touch anything.
1. Push the front hand guard (2) so that the chain
brake is engaged. (Fig. 13)
2. Set ignition switch (18) to ON position. (Fig. 14)
10
17
Fig. 12
2
Fig. 13
18
Fig. 14
3. Push priming pump (19) about ten times so that
fuel fl ows into carburetor. (Fig. 15)
20
4. Pull the choke control knob (20) fully (Fig. 15).
This will automatically lock the throttle in starting
position.
5. Pull recoil starter (21) briskly, taking care to keep
the handle in your grasp and not allowing it to
snap back. (Fig. 16)
21
6. When you hear fi rst ignition, push the choke
control knob (20) fully. (Fig. 15)
NOTE
When the choke control knob is put back to the
original position after it is fully pulled, the throttle
trigger will be kept half-open (half-throttled).
7. Pull recoil starter (21) briskly again in the
aforementioned manner. (Fig. 16)
NOTE
If engine does not start, repeat procedures from
4 to 7.
8. As soon as engine start, with the throttle trigger
lockout (22) pressed, pull the throttle trigger (23)
and immediately release the throttle trigger (23).
(Fig. 17)
Then half-throttle is disengaged.
19
Fig. 15
Fig. 16
22
23
Fig. 17