Cutting Tools; Installing The Tool On The Motor; Installing The Motor On The Machine - AXXAIR 121ECO1 Mode D'emploi

6.

Cutting tools:

When the machine is delivered, a blade is
installed on the cutting motor. You should
check that it corresponds to the tube you wish
to cut.
WARNING: It is imperative that the cutting
motor be disconnected from the power supply
before any handling of the motor or the cutting
tool.
AXXAIR saw blades are designed specially for
your orbital cutting operations. They are made
from high quality steels for optimal longevity.
They adapt to all types of materials currently
used.
The thickness of the tube being cut determines
the choice of blade to be used.
Reference: Thickness to be cut:
LS63100
LS6364
LS6872
LS6844
LS8080
LS8054
LS8034
Blades with large teeth are always preferable
when the thickness to be cut is at the limit of
the capacity shown above.
The arrow indicates the tool's direction of
rotation.
The hole positions the cutter and avoids all
excessive clamping during usage.
ENGLISH
0.7 to 1.5 mm
1.0 to 3.0 mm
1.0 to 3.0 mm
2.0 to 7.0 mm
1.0 to 3.0 mm
2.0 to 7.0 mm
5.0 to 12.0 mm
F-26800 ETOILE-SUR-RHONE
7.

Installing the tool on the motor:

WARNING: The motor should always be
disconnected from the power supply.
These tools are sharp; appropriate gloves
should therefore be used when installing and
uninstalling the cutting tools.
Note: All support surfaces should always be
cleaned.
- Place the blade in such a way that the
direction of rotation shown on the tool
corresponds to the direction of rotation
of the cutter's motor. With this type of
tool we always counterwork, i.e. the
direction of rotation of the tool is the
opposite to the direction of rotation of the
forward motion.
Place the disc over the blade, ensuring
-
that the pin is correctly positioned.
Note: The pin is not a driving bolt; it's used
to prevent the blade from over-tightening
during usage and to allow easy uninstalling
and changing of the blade.
- If the cutting tool used does not have a
hole, mount the support disc with the pin
toward the exterior.
- Put the nut in place and tighten with the
key provided for that purpose. It needs to
be tightened hard (by tapping the key) to
keep the tool from loosening.
8. Installing the motor on the
machine:
WARNING: Clean all support surfaces well
before installing the cutting head on the
motor's supporting plate. Using the brush
provided, clean the surface of the tool
supporting plate as well as those of the cutting
heads. The quality of the cuts depends on the
geometry of these support surfaces.
The motor
-
supporting plate by sliding it into the slot
provided for that purpose.
The motor's positioning is assured by two
-
preinstalled plates, which ensure that the
angle head adheres to the support surface
of the tool supporting plate.
- 13 -
Z.I. Les Bosses
www.axxair.com
is installed on the tool