Mounting/Installation; Hdcc32560 - Abus HDCC32560 Notice D'utilisation

3. Mounting/installation

IMPORTANT!
The camera must be disconnected from the power supply during installation.
3.1.

HDCC32560

Glue the drilling template provided where you intend to install the camera. Drill the required holes.
Turn the locking ring anticlockwise from the camera. Use the two anchors on the underside of the
camera base plate to exert a counterforce.
Use the screw anchors and screws provided to mount the camera base plate in place.
If the cable is to be routed through the side, do not fully mount the camera base plate until
the camera and the camera cap are in their place.
Place the camera on the camera base plate and lay the cable through the wall or side. Clip the camera
cap on and align the camera and camera cap.
Turn the locking ring clockwise to fix the camera in position.
Alignment
1. Inclination: 0–75°
2. Panning: 0–360°
3. Rotation: 0–360°
10
English