EIBENSTOCK MXT 110 C Notice Originale page 12

When inserting the tool, you could catch your hands. For this reason,
always wear protective gloves for changing the tool.
The work spindle of the machine has an M 14 - internal thread. Keep
threads and front surface clean.
Please hold up with a jaw wrench 22 to remove the stirring rod.
Switching on and off
Short-Time Operation
Switching-on: press the on/off switch
Switching-off: release the on/off switch
Permanent Operation
Switching-on: press the on/off switch and, keeping it pressed, engage the
lock-on button
Switching-off: press the on/off switch and let it go off again
Attention!
In case of every stop of the machine or a power cut, the
!
lock-on button has to be released immediately by pressing
the ON/OFF switch. So you can avoid an unintentional
restart of the machine (physical hazard).
The stirrer is equipped with an electronic switch.
With this switch the speed can be regulated according to the pressure on
the button. The use is only recommended for the starting and running out of
the machine to avoid material flying around. A permanent operation with
reduced speed will cause an overload because the motor then gets less
cooling air and therefor the machine will be overheated much faster.
Tool Protection
Wrong handling can cause damages on the tool.
There for, please always observe the following instructions:
Use only stirring rods recommended with M 14 – internal thread (diameter
120 mm max.) which are recommended by the producer.
Do not allow blocking of the tool due to overload.
Only use original accessories made by EIBENSTOCK.
Care and Maintenance
Before the beginning of maintenance or repair works you
have to disconnect the plug from the mains.
Repairs may be executed only by appropriately qualified and experienced
personnel. After every repair the machine has to be inspected by an
electric specialist.
12