EIBENSTOCK MXT 110 C Notice Originale page 10

Technical Data
Stirrer MXT 110 C
Rated voltage:
Power input:
Rated current:
Rated speed:
Max. basket diameter:
Weight:
Frequency:
Thread connection:
Protection class:
Degree of protection:
Interference suppression:
Stirrer with stirring rod and operating instructions in a set cardboard box
Application for Indented Purpose
The Stirrer MXT 110 C is designed for use in mixing paint, glue, tile cement
and other media in batches up to about 40 kg.
The diameter of the used stirring rods should not exceed 120 mm.
Safety Instructions
Safe work with the machine is only possible, if you read
these operating instructions completely and strictly
follow the instructions contained herein.
In addition, the general safety instructions in the
enclosed brochure have to be observed. Take part in a
practical introduction before the first use.
If the connection cable is getting damaged or cut during the
work, don't touch it, but instantly pull the plug out of the
socket. Never use the machine with damaged connection
cable.
The machine must neither be wet, nor be used in humid
ambient conditions.
Do not use the tool for mixing materials either in danger of explosion or
easily inflammable.
Do not carry the tool at its cable.
Always check the tool, cable and plug before use. Have damages only
repaired by specialists. Only insert the plug into the socket when the
tool switch is OFF.
Supply
230 V ~
1100 W
4.9 A
0 – 500 rpm
120 mm
about 4.9 kg
50 - 60 Hz
M 14 i
II
IP 20
EN 55014 and EN 61000
10