Error Codes - Danby Designer DUF206E1WDD Guide D'utilisation Et D'entretien

Réfrigérateur et congélateur vertical convertible
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
PROBLEM
Does not work
Appliance runs
continuously
Internal temperature not
cold enough
Temperature inside the
appliance is too cold
Noises coming from
the appliance (popping,
cracking, gurgling)

ERROR CODES

E2: Temperature sensor failure.
E5: Defrosting sensor failure.
E6: Communication failure.
E7: Ambient temperature sensor failure.
E9: High temperature.
To clear all error codes, unplug the appliance and let it stand undisturbed for 5 minutes, then plug it
back in. If the error code persists, contact consumer care for further troubleshooting.
Danby Consumer Care: 1-800-263-2629
POSSIBLE CAUSE
No power to appliance
Power cord is unplugged
Wrong voltage is being
used
Temperature set too low
(cold)
Door is not closed
Hot food was inserted
Door opened too long or
too often
Close proximity to heat
source or direct sunlight
Quick Freeze function is
set
No power to appliance
Power cord is unplugged
Temperature set too high
(warm)
Lid is not closed
Hot food was inserted
Lid opened too long or
too often
Air fl ow obstruction
Wrong voltage is being
used.
Close proximity to heat
source or direct sunlight
The temperature control
is set too cold
Internal parts are
expanding and
contracting
Refrigerant is circulating
in the system
9
SOLUTION
Check connection of power cord to
power source
Plug in appliance
Use proper voltage
Set temperature control to warmer
setting
Close door securely
Be sure food is at room temperature
before inserting
Minimize door openings / duration
Do not place appliance close to heat
sources or direct sunlight
This is normal
Check connection of power cord to
power source
Plug in appliance
Check setting and adjust as needed
Close lid securely
Be sure that food is at room
temperature
Minimize lid openings / duration
Allow room for air to circulate around
appliance
Use proper voltage
Do not place appliance close to heat
sources or direct sunlight
Adjust the temperature setting
This is normal
This is normal

Publicité

Table des Matières
loading

Table des Matières