Hiding The Camera; 2: Connecting The Tv - Sony BRAVIA KDL-65W950B Mode D'emploi

Detaching the Table-Top
Stand from the TV
To detach the Table-Top Stand from the TV,
remove the screws
~
• Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
• Be sure the TV is vertical before turning on.
To avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
• When attaching the Table-Top Stand again,
be sure to fasten the screws (previously
removed) to the original holes on the rear of
the TV.

Hiding the camera

If you do not wish to use the camera, hide it
as illustrated.
12
US
.

2: Connecting the TV

~
• Use an antenna cable connector no greater
than 14 mm thick.
• When connecting the cable to the Cable/
Antenna, input finger tighten only, over
tightening the connection can damage the
TV.
• Before moving the TV, disconnect all of the
cables connected to the TV to prevent
damaging the TV when it is moved.
• Use an HDMI cable connector within 12 mm
(thickness) × 21 mm (width).
• For more information on connections, refer to
the i-Manual.
x Shown with a Set Top Box with
HDMI connection
Set Top Box