Touch Sensor Tone; Manual Clock Adjustment; Si (System Indicator); Display Illumination Control - Kenwood DNX210EX Mode D'emploi

In Standby mode

Touch Sensor Tone

Setting the operation check sound (beep sound)
ON/OFF.
Display Setting
"BEEP ON" Beep is heard.
"BEEP OFF" Beep is canceled.
In Standby mode

Manual Clock Adjustment

1
Select Clock Adjustment mode
Push the Control knob towards [FM] or [AM].
Select the "CLK ADJ" display.
2
Enter Clock Adjust mode
Press the Control knob for at least 1 second.
The clock display blinks.
3
Adjust the hours
Push the Control knob towards [FM] or [AM].
Adjust the minutes
Push the Control knob towards [4] or [¢].
4
Exit Clock adjustment mode
Press the [MENU] button.
In Standby mode

SI (System Indicator)

The red indicator blinks when the ignition key of
the vehicle is at the OFF position.
Display Setting
"SI ON" LED flashes.
"SI OFF" LED OFF.

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display Setting
"DISP ON" Keeps the display on.
Turns off the display when you perform no
"DISP OFF"
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 20) is set to OFF.
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Turning off the power
• During function control, such as the Menu System, the
display stays on.

Dimmer

You can lower the brightness of the display by using
the dimmer function.
Display Setting
"DIM ON" The display dims.
"DIM OFF" The display doesn't dim.
17
|
English