Sp347 - Star SP317 Guide D'utilisation

2-2. SP347

Rear cover
Power off
Fig. 2-5 Removing the rear cover (SP347)
4 Adjust DIP switch 2-4, the roll paper holder and the adjust lever position
according to the width and thickness of the roll paper that is being used.
• Refer to Installation Manual in regard to the position of the DIP switch.
• If you do not know the standard position of the adjust lever, lower the adjust
lever as far as it will go (on the rear cover side), and then pull it two positions.
That position is standard position A.
Paper
Paper width Thickness
1 sheet of paper
2.25 inches
Printer paper
1 sheet of paper
3.0 inches
Printer paper
1 sheet of paper
3.25 inches
Printer paper
1 Turn the power switch on the printer
to the off position.
2 To remove the front cover lift it up
approx. 3cm. and pull it forward.
NOTE: Do not touch the print head
3 To remove the rear cover lift it up
approx. 3cm and push it backwards.
DIP switch 2-4 Adjust lever
(Fig. 4-1) position (Fig. 2-6)
OFF
OFF
ON
ON
ON
ON
– 7 –
immediately after printing
as it can be extremely hot.
Roll paper holder
(Fig. 2-7)
A Used (Inner groove)
B Used (Inner groove)
A Used (Outer groove)
B Used (Outer groove)
A Not used
B Not used