Adjusting The Feet; Electrical Connection; Initial Use - Beko WTE 7611 BW Manuel D'utilisation

4.1.6 Adjusting the feet

A
CAUTION:
and balanced on its feet. Balance the machine by adjusting the feet. Otherwise, the product may move from its
place and cause crushing and vibration problems.
CAUTION:
1 Loosen the lock nuts on the feet by hand.
2 Adjust the feet until the product stands in a stable and balanced way.
3. Tighten all lock nuts by hand again.

4.1.7 Electrical connection

Connect the product to a grounded outlet protected by a 16 A fuse. Our company shall not be liable
for any damages that will arise when the product is used without grounding in accordance with the
local regulations.
• Connection must comply with national regulations.
• The wiring for the electrical outlet circuit must be sufficient to meet the appliance requirements.
Use of a Groud Fault Circuit Interrupter (GFCI) is recommended.
• Power cable plug must be within easy reach after installation.
• If the current value of the fuse or breaker in the house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• The voltage specified in the "Technical specifications" section must be equal to your mains
voltage.
• Do not make connections via extension cables or multi-plugs.
B
CAUTION:

4.1.8 Initial use

C
Use an anti-limescale suitable for the washing machines.
Some water might have remained in the product due to the quality control processes in the production. It is not
harmful for the product.
Washing Machine / User's Manual
In order to ensure that the product operates more silently and vibration-free, it must stand level
Do not use any tools to loosen the lock nuts. Otherwise, they will get damaged.
Damaged power cables must be replaced by the Authorised Service Agents.
Before starting to use the product make sure that the preparations
are made which are in line with the "Important Safety and
Environment Instructions" and the instructions in the "Installation"
section.
To prepare the product for washing laundry, perform first operation
in Drum Cleaning programme. If this program is not available in your
machine, apply the method which is described in the section 4.4.2.
9 / EN