Engine Operation; Starting The Engine; Starting A Cold Engine - Echo PB-760LN Manuel D'utilisation

Engine operation

Starting the engine

When starting the engine, observe the precautions described from Page 4 in the section "For safe use of your prod-
uct" to ensure that you operate the product correctly.
Failure to observe the precautions could cause an accident or injury, or even lead to a fatality.
NOTE
Pull out the starter grip gently at first, and then more rapidly. Do not pull the starter rope out to more than 2/3 of its length.
Do not let go of the starter grip as it returns.
To start the engine, return the choke knob when you hear the first explosion-like sound and pull on the starter grip again. Be
careful not to miss the first explosion-like sound.

Starting a cold engine

1. Throttle Position / Stop
Switch Button
1. Choke
1. Recoil starter handle
WARNING
2. Purge bulb
Engine operation
Recoil starter: Use short pulls - only 1/2-2/3 of rope length for
starting. Do not allow the rope to snap back in. Always hold
the unit firmly.
1. Throttle Position / Stop Switch Button
Slide Throttle Position / Stop Switch Button back to idle posi-
tion (first detent away from stop position).
2. Choke
Move choke lever to
3. Purge Bulb
Pump purge bulb until fuel is visible.
4. Recoil Starter
Place the blower on a flat, clear area. Hold the blower firmly
with left hand and pull out the starter grip gently at first, and
rapidly pull recoil starter handle/rope until engine fires, or
maximum 5 pulls.
5. Choke
Move choke lever to
gine.If engine does not start after 5 pulls,repeat instructions 2-
5.
6. Engine start
Allow engine to warm up before use.
16
position.
position and if necessary, restart en-