Airphone JF-2MED Manuel D'installation Et D'utilisation page 10

8
OPERATIONS
8-1 Answering a door call (HANDS-FREE mode, PTT mode)
1
Press CALL button.
2
Chime tone sounds, caller is seen on video monitor, and
outside sound is heard.
• Audio and video turns off after approx. 45 seconds in not
answered.
3
Press TALK button momentarily, and after the beep, communicate
hands-free. Transmit LED (red) lights when you talk, and goes off as
you listen to caller (or hear outside sounds).
4
Press TALK button once again, and after the beep,
communication ends.
NOTES: Communication (video) ends automatically after approx. 1 minute.
8-2 Activating door release
1
During communication, instant voice call or entrance monitoring,
press MENU/MEMO button to display the menu screen.
2
PRE SS
THE TALK
BUTT ON
TO END .
3
PRESS THE TALK BUTTON TO END
- 10 -
Instant voice call function
2
Even without answering, door area can be seen and heard with video
and audio (for approx. 45 seconds). Inside sound is not heard outside.
NOTES: Not available on JF-D audio door station.
PTT mode
3
Press and hold TALK button for 1 second or more to change to press-to-
talk mode. A beep sounds, and after approx. 1 second another beep
sounds, PTT mode is entered. If TALK button is pressed briefly (less
than 0.5 seconds), communication ends.
4
To continue speaking using the press-to-talk mode, press TALK button
for 1 second or more each time to talk, and release to listen to the caller.
5
Press TALK button again momentarily, and after the beep,
communication ends.
NOTES: If the blue and white wires of the option connector are
shorted, PTT mode will not be operable.
Press CALL button.
NOTES: When SET DOOR RELEASE setting is set
PRESS THE TALK BUTTON TO END
Open door while the release mechanism is activated. During activation of door
release, the release symbol is displayed.
PRESS THE TALK BUTTON TO END
to "Not use", the release symbol
is not displayed and the release cannot be
performed. (Refer to section 7-8)