Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
.
English
•
Hold the appliance by insulated gripping
surfaces only, because the metal heating
head may contact hidden wiring or its own
cord.
Immediately switch off the appliance
when:
•
Plug and/or cable are defective or
damaged;
•
The switch is defective;
•
You smell or see smoke caused by
scorched insulation from the hot air gun.
Electrical safety
When using electric machines always observe
the safety regulations applicable in your coun-
try to reduce the risk of fire, electric shock and
personal injury. Read the following safety
instructions and also the enclosed safety
instructions.
Always check that the power supply
corresponds to the voltage on the
rating plate.
Class II machine – Double insulation
– You don't need any earthed plug
Replacing cables or plugs
If the power cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person, in order to
avoid a hazard.
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The mini-
mum conductor size is 1.5 mm
cable reel always unwind the reel completely
Inadequate extension cords can be danger-
ous. If an extension cord is used, it shall be
suitable for outdoor use, and the connection
has to be kept dry and off the ground. It is
recommended that this is accomplished by
means of a cord reel which keeps the socket
at least 60 mm above the ground.
8
7063005-Maxxheat-Eco-Ma-1712-21.indb 8
CONNECTING TO POWER SUPPLY
This product is designed with a cord retainer
that prevents the extension cord from being
pulled loose while using.
NOTICE: Always use cord retainer to properly
attach extension cord to the machine. Failure
to use cord retainer may result in damage to
the machine and/or extension cord.
•
Form a loop with the end of the extension
cord.
•
Insert loop portion of extension cord
through opening and place over cord
retainer.
•
Slowly pull loop against cord retainer until
the slack is removed.
•
Plug product into extension cord.
NOTE: Failure to remove all excess cord slack
from extension cord retainer could result in
plug loosening from receptacle.
CONTENTS
1 Weed Killer
1 Nozzle for surface weed control
1 Heating pin for underground weed control
1 Extension handle (2 parts)
1 Instruction manual
PRODUCT
Fig. A
. When using a
2
1.
On / off switch
2.
Temperature switch
3.
Ventilation openings
4.
Hot Air nozzle
5.
Extension handle
6.
Handle
7.
Lock button for extension handle
8.
Stand
9.
Nozzle for surface weed control
10. Heating pin for underground weed control
04-01-18 11:01
Publicité
Table des Matières
