NetSpa VITA Guide D'installation Et D'utilisation page 31

Press the filter button to activate the water filtration. The green indicator light will
turn on when the filtration system is activated.
Note:
- If massage function is on, the filtration can't be activated.
Press the heating button to activate water heating and filtering system at the
same time. The green indicator light of filter and red indicator light of heating will
turn on at same time
The pump does not stop heating until the current water temperature reaches the
set temperature; and the heating system will restart after the current water tem-
perature drops 2°C below the set temperature automatically.
Maximum heating temperature: 42°C (107°F)
Important :
After 150 cumulative hours of filtration operation, the message "CHG FIL"
is displayed on the filter block. This message is an automatic reminder to
indicate that it is time to change the filter cartridge.
To delete the message, hold the "filter" button for 5 seconds.
Note :
- The heating system is dependent on the filtration system and it can operate without.
- After turning off the heating system, the filtration system will still work.
- If the massage function is active, the filtration and heating functions can be activated.
5.3. Pool cover and security
After each use, the control panel must be locked and the pool must be coated with its
top cover and it must be attached to the base protector with the safety buckles.
Each safety buckles has a lock system ; closed buckle, the latch in up position locks
the buckle, the latch in down position unlocks the buckle.
The top cover keeps the heat from the water and secures the pool.
5. USAGE
EN