NetSpa CAÏMAN Guide D'installation Et D'utilisation page 25

The number of persons required for installation: 1 adult at least.
3.3. Assembling
1) Unfold the inflatable spa over the
double skin cover.
4) Insert the inflation hose into the
inflatable spa
7) Remove the inflation hose and
screw the cap firmly in place.
10) Check that the drain plug is closed
properly.
Warling : Do not leave spa unattended while filling with water.
Make sure the drain fitting is plugged securely and the cap is in place. Start filling the spa with water. After
about 1-inch of water is on the bottom, stop filling and smooth wrinkles out of the bottom of the spa. Pull
the outer wall out from the top edge, all around the bottom of the spa, so that it fills evently.
15 minutes for site preparation and water filling.
2) Bring the pump unit to the inflatable
spa.
5) Connect the pump unit then press
the button
The air flow valve prevents your spa
from over-inflating.
8) Connect the unit pump to the pool
using the 3 connectors to screw.
Ensure the icons on the pump and the
pool match up
11) Remplissez le spa avec 10 cm
d'eau.
Continue filling the spa until waterf level.
3) Connect the inflation hose to the
pump on the socket
6) Before inflating, check that the liner
to inflate the spa. fittings fall in front of double skin cover.
Inflate the inflatable spa for about 10
minutes. Ensure that the spa is firmly
inflated.
9) Insert the cartridge into its filter
holder and then screw on the suction
fitting inside the basin.
12) Smooth wrinkles out of the bottom
of the spa, then fill the spa to the level
indicated. Your spa is ready.
EN
.
25