Quick Start - Ecler nuo 3.0 Manuel Utilisateur

4. QUICK START

Install and connect the NUO3.0 as described in the INSTALLATION paragraph nº1.
We will describe a "Quick Start" procedure
using the LINE input of channel 1 and
headphone monitoring output only.
1. Set the controllers to their initial
position
Set the rotating controllers GAIN, HI, MID and
LOW from channel 1 (3, 4, 5, 6) to their
central position. Set the channel's fader (11)
to its lower end and assign the A/OFF/B
switch (10) to position A (the channel is now
assigned to the crossfader's A side).
2. Connect the headphones
Connect them to the headphones output (30).
Set the headphones LEVEL controller (23) to
minimum level and move the SELECT (22)
controller into PFL position.
3. Connect a CD player
Connect a CD player to LINE input on
channel 1 (37), insert a CD and play the CD.
4. Connect the mixer's power cable
Connect the power cable to the mixer's power
supply input (41) and turn it on using the
MAINS INPUT switch (43). Both elements are
located on the mixer's backside.
5. Select the input source
Make sure that channel 1's input switch (1) is
in LINE position and that the channel's VU-
meter (2) glows up. If this doesn't happen,
verify that the CD player is correctly
connected and that there is an audio track
being played back.
6. Adjust the input level
Move the GAIN (3) control until the VU-meter
shows 0dB.
7. Send the signal to the main output
Move the fader from channel 1 (11) all the
way up and set the crossfader (12) to side A.
8