Quick Start - Ecler NUO4 Mode D'emploi

4. QUICK START

Install and connect the NUO4 as described in the INSTALLATION paragraph nº1.
We will describe a "Quick Start" procedure using the H-LINE input of channel 1 and headphone monitoring output
only.
st
1 - Set the channel controls. Set the input switch (2)
to H-L. Set Channel 1 GAIN, TREBLE, MID, BASS
(1, 5, 6 y 7) rotary controls to their detented centre
position. Set the BASS OFF (8) switch to its up
position (BASS ON). Set the channel fader (13) to its
down position and assign the XFA/MIX/XFB (12)
selector to XFA (your channel is assigned to
crossfader A side).
nd
2 - Adjust the MONITOR VOL (22) to its minimum,
and move the MONITOR PFL/MIX (23) control to
MIX position.
rd
3 Connect a CD player to the channel 1 H LINE
input (41).
th
4 - Connect a pair of headphones to the MONITOR
Jack output (21).
th
5 - Connect the AC main power cord (58) to the
back of the mixer and switch ON (57) the mixer.
th
6 - Check that the POWER LED below the
VU-Meter (28) is lit.
th
7 - Start the reproduction of a CD music track.
th
8 - Press the yellow led PFL (9) button on channel 1
and adjust GAIN so that the left VU-Meter stays
around 0dBV.
th
9 - Set the channel fader (13) to its up position and
place the crossfader (14) on the "A" side.
th
10 - Adjust the MONITOR VOL (22) in order to
reach a "comfort" sound level in your headphones.
th
11 - Check the powerful 3 band stereo equalization
(5-6-7). The EQ system is designed for creative
sound performance:
independently isolated (OFF) through a large
ergonomic rotary control, and a BASS OFF switch
allows a fast bass frequency "kill" effect.
th
12 - Check the crossfader (14) action
MIX position bypasses the crossfader function. The crossfader will allow you to fade the signals assigned at each
side A & B of the slider. The movement of the crossfader allows you to create a smooth music track blend or a fast
"scratch" sound cuts. The fade curve can be very precisely adjusted thanks to the CUT-IN (19) knob* (fade-in
point), the SWITCH/FADE selector (17) (Rounded or Squared curve), the REVERSE selector (18) (Reverse the
sense of the crossfader) and fine curve control (20).
For further operations, please read the rest of this manual.
*Only if an "eternal" crossfader is installed.
8
each band can be