Wellis Clement WF00031 Manuel D'installation page 4

EN
4-3-3 Establish position for the pan. Mark
hole position on the floor, ensure the align-
ment by the spirit level.
4-3-5 Attach the extensible pipe (not
included) to the drain hole and apply the
waterproof PVC sealant around the hole.
4-3-7 Fix the pan by tightening the screw
by screwdriver and insert the plastic wash-
er and cap as above picture, do not over
tighten.
Connect the water source to the inlet valve by assembly the hose(not supplied).
Turn on the water valve and flush several times and check for leaks.
not included
Plastic plug
Installation screw
Deco Cap
Installation screw
Plastic plug
55 mm
4-3-4 Drill holes with 10mm diameter;
ensure the holes at 55mm away from the
marked position. Fix the L-shape braket
onto floor and tighten the screw. Do not
over tighten.
4-3-6 Locate the pan and connect the other
end of pipe to the pan.
4-3-8 Use the silica gel to seal the joint of
the WC pan and the floor surface.
Fixing set