Makita M9000 Manuel D'instruction page 7

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing side grip (handle)
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
011100
Screw the side grip securely on the position of the tool
as shown in the figure.
Installing or removing wheel guard
(For depressed center wheel , multi disc ,
abrasive cut-off wheel , diamond wheel)
WARNING:
When using a
•
wheel/Multi-disc, the wheel guard must be fitted on
the tool so that the closed side of the guard always
points toward the operator.
When using an abrasive cut-off / diamond wheel,
•
be sure to use only the special wheel guard
designed for use with cut-off wheels.
3
011101
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel
procedure in reverse.
depressed center
1. Wheel guard
1
2. Screw
3. Bearing box
2
guard, follow the
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
011625
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
with its protrusion facing downward (facing toward the
wheel).
NOTE:
In countries other than United States and Canada,
•
Inner flange 45 can be also used.
2
011104
grinding
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
OPERATION
WARNING:
It should never be necessary to force the tool. The
•
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
ALWAYS replace wheel if tool is dropped while
•
grinding.
NEVER bang or hit grinding disc or wheel onto
•
work.
Avoid
•
especially when working corners, sharp edges etc.
This can cause loss of control and kickback.
NEVER use tool with wood cutting blades and
•
installation
other sawblades. Such blades when used on a
grinder frequently kick and cause loss of control
leading to personal injury.
7
1
2
3
1
bouncing and
1. Lock nut
2. Depressed
center grinding
wheel/Multi-disc
3. Inner flange 89
1. Lock nut
wrench
2. Shaft lock
snagging the wheel,