Yamaha RX-A670 Guide De Démarrage Rapide page 13

6
Connecting the power cable to an AC wall outlet,
and turning on the unit
1
Plug the power cable into an
AC wall outlet.
To an AC wall
outlet
2
Press z (receiver power) to
turn on the unit.
SLEEP SLEEP
HDMI HDMI
1 1 2 2 3 3 4 4
ONE B ONE B
3
Turn on the TV and switch the
TV input to display video from
the unit (HDMI OUT jack).
The Network Setup screen shown below will be
displayed on the TV when the unit is turned on for
the first time after purchase. It may take several
tens of seconds for the screen to be displayed
(WAC: Wireless Accessory Configuration).
z
See "Sharing the iOS device setting" under
"Connecting the unit to a wireless network" in the
Owner's Manual when using this function to
connect the unit to a network.
This document explains wireless connection
using methods other than this function. Follow
the procedure described under "Connecting the
unit to a network" on the next page.
Note
This screen will not be displayed if the unit is connected
to a router via its NETWORK jack (wired connection).
Network Setup WAC
You can share the network's
wireless (Wi-Fi) setting with
this device using a device
with iOS7 or later.
↓ NEXT
To perform network setup using
another method, press ENTER.
CANCEL
RETURN
Language <English>
En
13