Setting The Height Of The Flames; Switching Off The Appliance; Failure; Control (Manual Control) - WANDERS Balsa 75 Mode D'emploi Et Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

failed. Possible cause: air in the pilot burner pipe.
Important: If the pilot flame has gone out you must wait at least 5 MINUTES before repeating the
!
above-mentioned steps.

Setting the height of the flames

After igniting the burner, the height of the flames will automatically reach the maximum position.
Press button  continuously to lower the flames and to switch off the burner (putting the fire out: "STAND
BY"). Press button  briefly to gradually lower the flames.
Press button  to increase the flame height. Briefly press button  to gradually increase the flames.

Switching off the appliance

Press button  to lower the flames and to switch off the burner.
Then press "OFF" button  to switch off the entire unit, including the pilot flame.
If the appliance is not used for a longer period it is advisable that you turn off the gas valve in the gas pipe.
Important: if the pilot flame has gone out for whatever reason, you must wait at least 5 MINUTES
!
before lighting the pilot flame again.

Failure

If it looks as if the signals of the remote control are not properly received by the stove (receiver), it may be
caused by:
Empty batteries: change the batteries.
An electronic problem: solve it by pressing the "RESET" button on the receiver.
If the appliance often switches off you should contact your installer.

Control (manual control)

If the batteries are due for replacement or if the receiver is defect, you can also operate the hearth by hand.
To do so, you need to disconnect the ignition (piezo) cable of the receiver and slide it gently onto the piezo
connection of the gas control block.
Lighting the fire and putting it out
1. Open the gas stopcock which is mounted in the gas pipe leading to
the appliance.
2. Press "O I" switch  on the gas control block in the "I" position.
3. Turn motor switch  on the gas control block all the way to the right.
The switch will make a ticking sound.
4. Turn operating switch  on the gas control block in the MAN
position; an orifice  becomes visible.
5. Push the metal pin in the orifice with something like a small pen. The
gas will now flow to the pilot.
6. While keeping the metal pin pressed in, press the (square) ignition
fuse  (next to the "O I" switch) to ignite the pilot flame. Look through
the glass to see whether the pilot flame is burning.
7. If the pilot flame is burning, keep the metal pin pressed for another
10 seconds and then release it. If the pilot flame dies, wait for another
5 minutes before repeating the above steps.
8. Turn operation knob  to the "ON" position.
9. Turn motor switch  to the left to ignite the burner and to select the
height of the flames.
20

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Balsa 100

Table des Matières