Charge Indicator Lights; Buttons And Indicator Lights - shark IQ ROBOT RV1000AE Série Guide D'utilisation

CHARGE INDICATOR LIGHTS

The blue indicator lights on the robot show how much charge is remaining.
While the robot is charging, both blue LED lights will flash. When charging is complete, both blue lights will
illuminate steadily. It may take up to 6 hours to fully charge your robot.
NOTE: If the low charge light is blinking red, there is not enough charge for the robot to return to the base. Manually
place the robot on the base.
s h a r kc l e a n . c o m
In Use
Full Partial Low
Charge Charge Charge
(Blue) (Blue) (Red)
While
Charging
(Blue)
No Charge
or Off

BUTTONS AND INDICATOR LIGHTS

!
CLEAN BUTTON
Press to begin a cleaning
session. Press again to stop.
RECHARGE & RESUME
Press and hold the CLEAN
button for 15 seconds to
turn Recharge & Resume
ON or OFF.
Turn ON Recharge & Resume for complete
coverage in larger homes. Your robot will return
to the dock to recharge for 4 hours, then resume
cleaning where it left off.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
Blue light: connected to
Wi-Fi.
Red light: not connected.
Flashing blue: setup mode.
No light: not set up yet.
NAVIGATION MODULE
Please keep clear and do not
cover.
Upward-facing sensor that
identifies unique reference
points to aid advanced
navigation.
DOCK BUTTON
Press to stop cleaning and
send robot back to the
charging base.
EVACUATE & RESUME
Press and hold the DOCK
button for 15 seconds to
turn Evacuate & Resume
ON or OFF.
Turn ON Evacuate & Resume for homes with pets.
Your robot will return to the dock to empty the
dust bin more frequently, then resume cleaning
where it left off.
s h a r kc l e a n . c o m