Ceado B210 Manuel D'utilisation page 16

16
12. Never pull the blender by the cord to move it. Never unplug it by pulling the cord or touching it
with wet hands.
If the cord is damaged, it must be replaced by an Authorized Service Center.
13. The blender is equipped with a safety device to prevent any contact with moving parts.
DO NOT ATTEMPT TO BY-PASS THE SAFETY DEVICE.
14. WARNING: Never place any utensils, metal or other hard materials, in the container. This is
dangerous and could cause damage.
15. Never operate the appliance with the container empty and never run it for more than 15
seconds if there are no liquids in the container.
16. Do not use the blender if it is damaged or had any loosened parts such as blades, couplings,
etc. In these cases, contact an Authorized Service Center immediately.
17. WARNING: BLADES ARE SHARP . HANDLE WITH CARE!
The EC declaration of conformity for this appliance is available in the Products section of our
website www.ceado.com.
INSTALLATION
Comply with the Safety recommendations indicated above and hereafter when installing the
appliance.
1. Make sure that the mains voltage is as indicated on the rating label of the appliance and that
the electric system is grounded and equipped with a differential switch.
2. Install the appliance in a DRY, PROTECTED place, far from water sprays or splashes, heat
sources, open flames and inflammable substances.
Place the blender on a flat, horizontal, stable surface where it cannot tip over.
3. Make sure the switch on the appliance is in the "OFF" position and plug it into a socket
protected by a magneto thermal switch or fuses.
Do not use a multiple outlet plug.
4. Stretch the power cable out to full length. Do not let it pass over sharp edges or hot surfaces.
Do not let oil spill on it. Do not let the power cable hang loose from the counter on which the
blender stands.
SAVE THESE INSTRUCTIONS!
GB