Assembling The Cigarette; Mode Of Operation; Notes On Use - DS Produkte MG85-401 Mode D'emploi

4. Insert the plug of the charger into a properly installed mains socket that is easily accessible.
The charge level indicator (fake fi re) on the front of the battery and the control lamp on the
USB adapter will begin to light up.
5. When the battery is fully charged up, the charge level indicator will go out. You can
now pull the charger out of the socket and unscrew the battery from the USB adapter.
Please note: The control lamp on the USB adapter light up continuously when it is connected
to the mains power.
6. Put the product back together again (see the "Assembling the Cigarette" chapter).

Assembling the Cigarette

1. Screw the battery into the atomizer.
2. If you have not already done so, remove the protective cap from the atomizer.
3. Place a cartridge (mouthpiece) onto the atomizer. Make sure that the cartridge and the
atomizer fully plug into each other.
The e-cigarette is now ready for use!

Mode of Operation

The central part of the e-cigarette is the atomizer. When you take a drag on the cigarette, the
atomizer is activated by a vacuum switch and the liquid with an aroma is vaporised from the car-
tridge (mouthpiece) to produce a fi ne mist which is then inhaled. At the same time, the vapour
is heated.

Notes on Use

• A fully charged battery is suffi cient for approx. 300 drags (depending on smoking habits).
• With each drag, the charge level indicator (fake fi re) lights up on the front of the battery.
If the charge level indicator starts fl ashing or is only weakly lit, the battery needs to be
charged up (see the "Charging up the Battery" chapter).
• When you take a drag on the cigarette, the sucking in of air may produce "whistling noises".
This is normal and does not indicate a malfunction.
• The contents of a cartridge (mouthpiece) are suffi cient for approx. 200 drags (depend-
ing on smoking habits). Change the cartridge whenever very little or no vapour is being
produced.
18