Operation; Stand Alone Operation - EuroLite LED QMS-8 RGB Mode D'emploi

The device must be installed in an absolutely horizontal position.
Always install the device via all fixation holes.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Before taking into operation for the first time, the installation has to be approved by an expert!

OPERATION

Set the address of each spot by selecting the respective number:
After you connected the effect to the mains, the EUROLITE LED QMS-8 RGB starts running.

Stand Alone operation

1. Chaser
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
LED QMS-8 RGB, you can select up to 9 different chasers with up to 500 steps.
Selecting a chaser
Press the MODE button. Select the desired chaser (che1-che8) via the UP or DOWN buttons
(che9 is sound controlled).
Select the desired chaser value via the F/S buttons. (Step Time or Fade Time)
For example: You choose che1 via the MODE button and then press the F/S button to select the desired
Step Time or Fade Time value.
Fade Time from 0 to 100%.
Step Time value from 1 to 500 times/minute.
The desired values can be selected via the UP or DOWN buttons.
Manual Color Mixing
Select the MODE button. Select the F/S button to begin. Use the UP and DOWN buttons to
mix RGB values.
DANGER TO LIFE!
18/39 51930260_V_1_1.DOC