Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A
Drill 2 Holes of 10.2mm Diameter With Space 68 to 77 mm Between 2 holes.
Locate the 2 Slotted Holes Gate Bracket above the Drilled Holes.
B
C
Place the End Motor Bracket to the Gate Bracket using the Appropriate Bolts and Tighten Properly.
Please note these bolts used to fixed front bracket to the gate are not provided due to the thickness
of each gate is different.
D
Insert the Lock Pin and Clamping Washers ref. F
Installation of Motor's Arms to Gates
EN
11
Publicité
Table des Matières
