Festo DAPZ−AR 0512a Notice D'utilisation page 34

DAPZ−...−AR
Setting the switching cam
non−attenuated switching / non−actuated switching
Valve OPEN
1
1. Open the valve.
2. Insert the adjusting tool in the second
recess (see Fig. 21).
3. Only if the inductive switch is not
attenuated/actuated 1:
Turn the adjusting tool in an
anti−clockwise direction until the switch
is attenuated/actuated 2.
4. Turn the adjusting tool in an anti−clock
wise direction until the switching point
is reached 3.
Please note
Before you start and fit the visual display:
S Insert the adjusting tool in the first recess again (status when supplied from
factory).
The lug of the adjusting tool must face towards the second recess
(see 1 in Fig. 20).
S Avoid any rotary movement when the adjusting tool grips into the internal
toothed wheel of the switching cam.
Only in this way can you put the device together again.
34
2 3
Valve CLOSE
4 5
1. Close the valves.
2. Insert the adjusting tool in the first
recess (see Fig. 21).
3. Only if the switch is not attenuated/
actuated 4:
Turn the adjusting tool in a clockwise
direction until the switch is attenuated/
actuated 5.
4. Turn the adjusting tool in a clockwise
direction until the switching point is
reached 6.
Festo DAPZ−...−AR 0512a English
6