Festo DAPZ−AR 0512a Notice D'utilisation page 30

DAPZ−...−AR
5. Connect the control cable.
S For connecting the upper switch
observe the circuit diagram with the
pin numbers 1, 2 and 3.
S For connecting the lower switch
observe the circuit diagram with the
pin numbers 4, 5 and 6.
6. Replace the mounting plate with the recess 1 facing the cable through hole.
Fig. 18
Please note
The red ring is turned by the cam shaft.
S Make sure that the cables are laid so that the movements of the red ring and
the green ring are not impaired.
7. Tighten the fastening screw 3 for the mounting plate by hand.
8. Tighten the union nut 2 of the cable through hole.
Max. tightening torque: 5 Nm
30
Fig. 17
1
Fig. 19
Festo DAPZ−...−AR 0512a English
2
3