Monitor Operation; Monitor Menu Settings; Testing The Backup Camera System; Replacing Fuses - AEG RC 3.5 Notice D'utilisation

24

4.3 Monitor operation

Image 13
On / Off button, lights up blue when
12
the monitor is powered on
Menu button for selecting the respective
13
adjustment mode
Forward / increase button
14
Back / decrease button
15
Guides (distance guides) on the display
16
to assist with reversing
Display image
17
Power on the monitor before using the backup
camera and off after use.

4.4 Monitor menu settings

Brightness
Contrast
Colour
Direction
Guidelines
Language English / German
Exit
Image 14
▪ Push the On / Off key
on the key lights up blue.
▪ Press the (M) button to access menu mode
The display will now show the menu settings for
approx. 7 seconds. The respective adjustment
mode will be displayed in yellow font.
▪ Each time the button (M) is pressed again the
menu will advance to the next level of settings.
12
13
14
15
16
17
On / Off
so the symbol ( )
12
13
▪ Use the buttons ( + )
increase, decrease or advance the following
menu items:
Brightness: adjusts the monitor brightness
Contrast: adjusts the monitor contrast
Color: adjusts the monitor's color intensity
Direction: adjusts the monitor display. Adjust
image upside down and left / right
Guidelines: can be activated or deactivated
Language: set language to English / German
Exit: leave menu mode
▪ In "Exit" mode press a ( + )
button to leave the menu mode.

4.5 Testing the backup camera system

▪ First engage the hand brake and verify the car
is not in gear. Turn the ignition to II, do not start
the engine!
▪ Plug in the monitor
3
cable into the 12 V vehicle outlet. Press the
2
button to power on the monitor. The sym-
12
bol ( ) on the button must light up blue.
▪ Now put the vehicle into reverse. The trans-
mitted camera image will now be displayed
on the monitor.

4.6 Replacing fuses

Retaining screw
Fuse 1 A (Ampere)
Contact cap
Spring
Image 15
▪ Unscrew the retaining screw.
▪ Remove the contact cap, spring and the
1 A (Ampere) fuse.
▪ Assemble all parts and the new 1 A fuse in the
order shown and tighten the retaining screw.
and ( - ) to
14 15
or( - )
14
15
by plugging the monitor
12 V plug
Vehicle connector