Publicité
Les langues disponibles
Les langues disponibles
KE-10
1.
SUB VOLUME
Use this button to adjust the signal level of the Subwoofer
2.
PHASE REVERSE
Use this switch to reverse the phase of the subwoofer.
3.
SAT VOLUME
Use this button to adjust the signal level of the Satellites.
4.
SPEAKER OUTPUT
Use these sockets to connect the satellite speakers, the speaker connector have a pin 1+ (hot) and 1-(ground).
5.
LEFT LINE INPUT CONNECTOR
This connection is designed to accept a balanced line input signal from a mixer, using a XLR connector.
6.
FULL RANGE OUTPUT
Balanced XLR output, connected in parallel to the inputs, to connect to another device.
7.
HIGH-PASS OUTPUT
Balanced XLR connector providing the high-pass output signal, to connect to other active speaker.
8.
LED INDICATORS
Power indicator when power on. Signal input indicator. Protect indicator, lights up red when protective circuit active. Limit Indicator, lights
up red when the signal level is too high, the limiter will reduce the signal level to protect the speakers.
9.
GROUND SWITCH
Groundlift selector switch, upper position the input signal and housing ground are connected, lower position are separed.
10. POWER SOCKET
Used to connect the main power cable.
11. POWER SWITCH
This button is used to switch on/off the unit.
TECHNICAL SPECFICATIONS
Sub
System Type:
Frequency Range :
Power Rating:
Impedance:
Maximum SPL***:
System Sensitivity (1w/1m):
Transport:
Dimensions (D x W x H):
Net Weight:
Sat
System Type:
Frequency Range :
Power Rating / Impedance:
Maximum SPL***:
System Sensitivity (1w/1m):
Dimensions (W x H x D):
Net Weight:
BST equipment is covered by a 2 years warranty on parts and labor
The following rules apply from the day the equipment leaves the factory:
The date on the invoice is considered to be the date the warranty begins.
Only companies approved by BST are allowed to work on the equipment. Warranty becomes void when other service technicians open the
equipment.
© Copyright LOTRONIC 2015
.
9
10" (25cm) Woofer, bass-reflex,
40 Hz - 250Hz
450 W RMS
8 ohms
125 dB SPL peak
97 dB SPL
2x integrated handle
525 mm x 335 mm x 415 mm
25 kg
Two-way, 6.5" (16.5cm) medium, Driver (1") 2.5cm, ABS Molded horn
70 Hz - 17 kHz
2x 150 W RMS / 8 ohms
112 dB SPL peak
95 dB SPL
193 mm x 202 mm x 375 mm
5.5 kg
x26 x dB crest factor.
www.bstdj.com
10
11
Page 3
Publicité
