SEVERIN GS 8856 Mode D'emploi page 20

Installation measures
If the appliance is placed sideways on a wall,
you will leave a lateral gap of at least 60 mm,
so that the doors of the appliance can open in
a 90-degree angle.
Width (W) Depth (D)
480 mm
A B
780 mm 913 mm
Height (H)
500 mm 850 mm
C E
125° 30 mm 100 mm
Ventilation
The air warmed behind the appliance needs
to circulate freely. For this reason, the circula-
tion of air cannot be compromised.
Caution! Do not cover possible existing
ventilation openings in the back area of the
top cover plate!
Connection
• Before you connect the appliance, you have
to make sure that itself and the power plug
do not show any transport damages.
• Connect the appliance only to a shockproof
outlet. The mains voltage has to correspond
to the one stated on the tool identification
plate.
• The appliance complies with the guidelines
that are obligatory for CE marking.
• Do not connect the appliance to an inverter
• The power plug should not touch the back-
side, in order to avoid possible vibration
noise.
• The appliance can be put into operation by
plugging the mains plug into the point.
• A complete switching-off only occurs by
pulling the mains plug.
F
• If the appliance has been disconnected
from the mains, wait approx. 5 minutes
after plugging in the mains plug before
setting the temperature controller to the
desired position.
- 20 -