Vacuum Operation - ArmorAll AA12V1 Manuel D'utilisation

GETTING TO KNOW YOUR VACUUM
A. 12V power plug
B. On/Off slide switch
C. Container release button
D. LED light
E. Filter
F. Filter holder
G. Container
H. Retractable crevice tool
I. Rubber squeegee
J. Detail brush
K. Store bag
L. Detail brush storage
TECHNICAL SPECIFICATIONS:
Voltage: 12V DC

VACUUM OPERATION

WARNING:
Do not run the vehicle's engine while cleaning. This can shorten the life of the vacuum.
CONNECTING TO THE VEHICLE'S POWER SUPPLY
1. Make sure that the vacuum is switched to the OFF position. (fig. 1)
2. Remove the cigarette lighter from the socket.
3. Insert the 12V power plug (A) into the 12V power socket. (fig. 2)
OPERATING THE APPLIANCE
1. To power on the vacuum, slide the ON/OFF switch (B) forward to the ON position. (fig. 1)
2. To power off the vacuum, slide the ON/OFF switch (B) back to the OFF position. (fig. 1)
NOTICE!
The LED light (D) in the upper portion of the vacuum will be illuminated when the
appliance is turned on. The light is useful to see in poorly illuminated areas.
NOTE:
The vac can be used for periods of up to 30 minutes without noticeably affecting the power of a
normally charged car battery in good condition.