Wagan Tech IONBoost Slim Guide D'utilisation page 9

3. Determine the polarity of the vehicle's battery terminals. The positive (POS,
P, +) battery terminal usually is red and larger in diameter than the negative
(NEG, N, −) terminal. If you are unsure, first refer to the vehicle owner's
manual. Make sure the negative battery terminal is also connected to the
vehicle frame.
4. If engine was recently cranked, use a non conductive material (cardboard
or a folded newspaper) to wave away (dispel) explosive gases. Do this for
a few minutes before any vehicle connections.
5. Insert the blue plug of the jumper cables into the iOnBoost's jumper
terminal. When fully inserted, the red and green lights on the cable safety
block should both flash continuously.
 Never allow clamps (positive & negative terminals) to touch together or
contact the same piece of metal to prevent short-circuits and arcing.
6. Securely connect the positive (+) red clamp to the positive (POS,
P, +) terminal of the vehicle battery or the remote positive (+) terminal if
equipped.
7. Securely connect the negative (−) black clamp to a non-moving, metal part
of the engine or frame as far away from the vehicle battery as possible.
8. When the clamps are properly connected to the battery, the green light
on the cable safety block will illuminate (a three-second delay is normal).
When the light illuminates steady green, it is safe to proceed in these
instructions. If the light fails to illuminate steady green or if any red lights
illuminate, consult the troubleshooting section of this manual.
9. Place unit on a secure surface away from moving parts.
10. Start vehicle engine. Stop if the vehicle does not start after 3 to 4 seconds
of engine cranking. Wait 3 to 4 minutes, then try again. If engine does not
start after second attempt, discontinue cranking and consult a professional.
11. The internal safety timer will automatically disconnect the circuit after 30
seconds to prevent the vehicle battery from reverse charging the unit. Both
the red and green lights will illuminate steady. If your vehicle still has not
started, disconnect the cables and try the procedure again.
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2018 Wagan Corporation. All Rights Reserved.
8