Installation Of The Telephone; Optional Connections - Unify OpenScape Desk Phone CP100 Guide Rapide

Installation of the telephone

See also overview on page 2.
Desk Installation
By mounting the stand on the telephone using the long or short end
you can select between 16° and 51° tilt angle:
long end: 16°
1. Place the phone upside down on a soft surface and remove all
cables from the phone except the handset cord d .
2. Insert the stand along the bars on the base of the telephone as
shown.
3. Slide the stand to the stop at the left until it locks into place.
4. If your LAN does not have PoE (Power over Ethernet; ask your
administrator), then you need to use a power supply connected
to the power jack
5. Connect the LAN cable with the jack
telephone and the wall jack.
Wall Installation
Wall mounting on a wall mounting kit and on a wall is possible with
the integrated stand. More information on this topic can be found
here: http://wiki.unify.com.

Optional Connections

If desired, you can connect further devices to your phone (see also
overview on page 2):
Connection to PC
A
If further settings are required for correct operation of the telephone,
please contact your administrator.
10
.
B
short end: 51°
C on the base of the