Installation Of The Telephone; Optional Connections - Unify Atos OpenScape CP110 Guide Rapide D'installation Et De Référence

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13

Installation of the telephone

See also overview on page 2.
Desk Installation
By mounting the stands on the telephone using the long or
short end you can select between 22,5° and 45° tilt angle:
Long end: 22,5°
1. Place the phone upside down on a soft surface and
remove all cables from the phone except the handset
cord
.
2. Insert the stands on the base of the telephone as shown.
3. Slide the stands until it locks into place.
4. If your LAN does not have PoE (Power over Ethernet; ask
your administrator), then you need to use a power sup-
ply connected to the power jack
5. Connect the LAN cable with the jack
of the telephone and the wall jack.

Optional Connections

If desired, you can connect further devices to your phone (see
also overview on page 2):
Connection to PC
B
Connection to Headset
D
If further settings are required for correct operation of the
telephone, please contact your administrator.
Short end: 45°
.
C
on the base
A
11

Publicité

Table des Matières
loading

Table des Matières