Oreck XL dutchTech DTX 1100 Guide D'utilisation page 5

G R
etting eady for
BUTTONS
CORD
CHANNEL
BUTTON
E N G
U
se
To assemble power
nozzle and wands,
Insert upper wand into
lower wand until button
locks. Insert lower wand
into power nozzle until
button locks. Once
assembled do not
disassemble.
Insert power nozzle plug
into the plug holder on
upper wand.
Pulling cord down, press
cord into cord channel on
bottom wand.
For convenience, do not
disassemble for storage.
Insert power handle into
upper wand until button
locks.
Pull plug from unit and
insert into wall outlet.
L I S H
O
perating
Polarized Plug Notice
This product is equipped with a polarized alternating
current line plug (a plug having one blade wider than the
other). This plug will fit into the power outlet only one way.
This is a safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the plug should
still fail to fit, contact an electrician to replace the obsolete
outlet. Do not defeat the purpose of the polarized plug.
If using a power nozzle,
turn the power nozzle
On/Off by using the switch
located on the handle.
CARPET
BARE FLOOR
To adjust suction, use the
suction control slide on the
standard handle and power
handle.
Small accessories can be
used with friction wand or
handle alone.
5
I
nstructions
Press the On/Off pedal
located at the rear of the
canister to turn on.
Using the standard nozzle,
the nozzle is adjustable for
use on carpets (without
brush) or hard floors (with
brush).
Upholstery tool, crevice tool
and dusting brush can be
found in storage
compartment.