Elb 1200 Battery Pack Functions - Elinchrom ELB 1200 Manuel D'utilisation

ELB 1200 BATTERY PACK FUNCTIONS

7
1. State of charge LED Indicator
2. State of charge / battery wake-up button
3. ELB 1200 charger socket
4. Communication Interface between the ELB 1200 battery and the ELB 1200 unit
5. Battery shut down socket and reset
6. USB charge socket
7. Battery terminals
BATTERY PACK CONNECTION
ELB 1200 Battery is intended to be used with the ELB 1200 flash unit ONLY.
Press down to lock
TO CONNECT YOUR BATTERY TO THE ELB 1200 UNIT:
1. Place the ELB 1200 unit on a flat, dry and clean surface.
2. Make sure the two locking buttons are in the upward (unlocked) position.
3. Place the charged ELB 1200 Battery on a clean surface and ensure that the protection
cover is removed
4. Place the ELB 1200 housing over the ELB 1200 Battery.
5. Press smoothly down onto the ELB 1200 housing until you hear two clicks (left/right)
locating the locking mechanism.
6. Visually check, that the battery pack is well connected on both sides of the unit.
7. Press down the two locking buttons on both sides of the ELB 1200 unit.
TO DISCONNECT THE BATTERY PACK FROM THE ELB 1200 UNIT:
1. Place the ELB 1200 pack on a flat, dry and clean surface.
2. Lift the 2 locking buttons on both sides of the housing (unlocked position).
3. Slide the side bars as shown in the picture above.
1 2
Press up to unlock
User Manual
Grab and pull to open and
separate the battery from the unit
EN
3
4
5
6
5