Publicité
Les langues disponibles
Les langues disponibles
Remove from below the vehicle any protective sealant from the points of contact between the shell and the tow bar; then paint the
uncovered parts with rust preventer. The holes for the tow bar's fixing are available.
1.
Disassemble the rear bumper and its inner reinforcement eliminating its supports.
2.
Disassemble the exhaust pipe's support, the heat guard cladding, the spare wheel and the luggage compartment's inner
cladding.
3.
Insert drawbeam's "A" tie beams within the spars and place with reference to holes "1".
4.
From inside the luggage compartment with reference to holes "1" place the wide washers "B", insert screws and then fix.
5.
Make a cut on the bumper's inner reinforcement middle side as shown in the enclose layout.
6.
With reference to holes "2" which can be found on the drawbeam, place the inner reinforcement, insert screws and then fix.
7.
Tighten all bolts and nuts with a tightening torque as shown in the enclosed layout.
8.
Connect the wiring to the socket (usually given apart), following the car booklet's instructions "use and maintenance" as
shown in the enclosed wiring kit layout.
9.
Reassemble the exhaust pipe's support, the heat guard cladding and reallocate the spare wheel and the luggage
compartment's inner cladding.
10.
Make a cut on the bumper's middle side as shown in the enclosed layout.
11.
Reassemble the rear bumper.
•
Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also that the vehicle's towing
disposal quoted on the car registration is mentioned on the tow bar document. Otherwise ask for the appropriate office
(umbrarimorchi@umbrarimorchi.it) for explanations or updated documents.
•
For safety, all work involving tow bar installation must be undertaken by skilled technicians.
•
Damaged components must be replaced with manufacturer's spares parts by qualified staff.
•
It is forbidden to make any modification or structural repair to the tow bar.
•
The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be checked at regular
intervals. If the tow ball measures less than 49 mm after selected readings across the diameter, the tow ball must be
replaced with a new one.
•
After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.
FITTING INSTRUCTIONS
SAFETY INSTRUCTIONS
USE AND MAINTENANCE
02023 • 1.0 • 05/02/2014
6
Publicité
