UMBRA RIMORCHI 14082 Instructions De Montage page 6

Remove from below the vehicle any protective sealant from the points of contact between the shell and the tow bar; then paint the
parts with rust preventer. The holes for the tow bar fixing are available.
1. Disassemble the rear bumper.
2. Disassemble and eliminate the inner plastic panel placed behind the bumper.
3. Disassemble and eliminate the reinforcement cross bar.
4. Disassemble the rubber support and the heat guard cladding of the exhaust pipe.
5. Place the tie beams "B" inside the rear spars of the vehicle, in correspondence to holes "01" and "03"; insert screws only in
hole "01", interject the wide washers and then fix.
6. Insert the drawbeam "A" inside the rear spars of the vehicle, placing it in correspondence to holes "02" and "03"; insert
screws, interject in position "03" the wide washers and then fix.
7. Tighten all bolts and nuts with a tightening torque as shown in the enclosed layout
8. Connect the wiring to the socket (usually given apart), following the car booklet's instructions "use and maintenance" as
shown in the enclosed wiring kit layout.
9. Make a cut on the central and lower side of the rear bumper, as shown in the enclosed chart.
10. Reassemble the heat guard cladding, the rubber support of the exhaust pipe and the rear bumpers.
INVISIBLE AND SWIVELING SOCKETHOLDER FOR MODELS "C" "E" "VM"
• Make sure that the tow bar is suitable for the vehicle before starting the installation. Verify also that the vehicle's towing
disposal quoted on the car registration is mentioned on the tow bar document. Otherwise ask for the appropriate office
(umbrarimorchi@umbrarimorchi.it) for explanations or updated documents.
• For safety, all work involving tow bar installation must be undertaken by skilled technicians.
• Damaged components must be replaced with manufacturer's spares parts by qualified staff.
• It is forbidden to make any modification or structural repair to the tow bar.
• The tow ball must be kept clean and lubricated. For added safety, his diameter (50 mm) must be checked at regular
intervals. If the tow ball measures less than 49 mm after selected readings across the diameter, the tow ball must be
replaced with a new one.
• After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table.
FITTING INSTRUCTIONS
SAFETY INSTRUCTIONS
USE AND MAINTENANCE
14082 • 1.0 • 30/09/2015 6