Picture Options - Philips HTB3524/F7 Manuel D'utilisation

• [2nd Subtitle Language]: Select the
second subtitle language for Blu-ray
video.
[Titles]: Select a specific title.
•
[Chapters]: Select a specific chapter.
•
[Angle list]: Select a different camera
•
angle.
• [Menus]: Display the disc menu.
• [PIP selection]: Display Picture-in-
Picture window when playing a Blu-ray
disc that supports the Bonus View.
[Zoom]: Zoom into a video scene or
•
picture. Press the Navigation buttons
(left/right) to select a zoom factor.
[Repeat]: Repeat a chapter or title.
•
• [Repeat A-B]: Mark two points within a
chapter or track to repeat play, or turn
off the repeat mode.
[Picture settings]: Select a predefined
•
color setting.

Picture options

While viewing a picture, zoom into the picture,
rotate it, add animation to a slideshow, and
change the picture settings.
1
Press .
» The picture options menu appears.
2
Press the Navigation buttons and OK to
select and change the following settings:
[Rotate +90]: Rotate the picture 90
•
degree clockwise.
• [Rotate -90]: Rotate the picture 90
degree counter-clockwise.
[Zoom]: Zoom into a video scene or
•
picture. Press the Navigation buttons
(left/right) to select a zoom factor.
[Info]: Display picture information.
•
[Duration per slide]: Select the display
•
speed for each picture in a slide show.
• [Slide animation]: Select animation for
the slide show.
[Picture settings]: Select a predefined
•
color setting.
[Repeat]: Repeat a selected folder.
•
EN
14
HTB3524 _F7_UM_V2.0.indb 14
Musical slideshow
If the picture and audio files are from the same
disc or USB storage device, you can create a
musical slideshow.
1
Select an audio track, and then press OK.
2
Press , and go to the picture folder.
3
Select a picture, and then press
start the slideshow.
4
Press to stop slideshow.
5
Press again to stop music.
Note
•
Make sure that the picture and audio formats are
supported by your home theater (see 'File formats' on
page 21).
Radio
Listen to FM radio on your home theater, and
store up to 40 radio stations.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, or if fewer than five
stations are found, you are prompted to install the
radio stations again.
1
Extend the FM antenna at the back of your
home theater and place it away from the
TV or other sources of radiation.
2
Press RADIO.
» If you have already installed the radio
stations, the last channel that you
listened to is played.
» If you have not installed any radio
stations, the message AUTO
INSTALL...PRESS PLAY appears on
the display panel. press
3
Use the remote control to listen or to
change radio stations.
(Play) to
(Play).
3/11/2014 1:59:27 PM