Publicité
Les langues disponibles
Les langues disponibles
Frequently asked questions
The center speaker or rear speaker does not produce sound
Cause
Solution
To play a stereo sound source in multichannel, press the
AUTO SURROUND (mode that
SURR button or the ADV button to select your favorite
outputs the number of input
mode.
channels as it is) is selected
Example) Press the SURR button several times to select
upon 2-channel audio input
[EXT.STEREO].
such as TV, music, etc.
The subwoofer does not produce sound
Cause
Solution
To produce output from the subwoofer, change the speaker
The front speaker is set to
setting. (There are two ways.)
LARGE.
Method 1
(The low frequency component
Change the front speaker to SMALL.
will be produced from the
• The low frequency component will be produced from
front speaker instead of the
the subwoofer instead of the front speaker. When the
subwoofer when 2-channel
front speaker has a high capability to play low frequency
audio input such as TV, music,
components, we recommend not to change.
etc.)
Method 2
Change the subwoofer to PLUS.
• The low frequency component of the front speaker will be
produced from both the front speaker and the subwoofer.
Therefore, the bass sound may be too powerful. In that
case, we recommend not to change or to change using
Method 1.
For the procedure to change, refer to the "Speaker Setting"
in the CD-ROM's operating instructions.
HDMI, network, etc. operations become unresponsive
Cause
Solution
Try resetting. To reset, turn off the power, and press down
The operations of this receiver
the STANDBY/ON button on the front panel for 5 seconds
and connecting devices are
or more. (The power turns off in 5 seconds after the power
unresponsive.
is turned on. The receiver's setting will be maintained.)
Also try replugging the power cord of the connecting
devices.
To produce sound from TV
Refer to page 8 of the booklet to perform connection and setting.
To play, press the TV button to switch to TV input.
The remote control does not work
Cause
Solution
When operating the receiver
The operation mode of
• Start the operation after pressing the MAIN RECEIVER
the remote control is not
button.
switched.
To operate functions such as network and iPod
• Start the operation after pressing the button of each function
(NET, iPod, etc.).
• If still not working, press the MAIN RECEIVER button first and
then press the button of each function.
2 TVs (projector) are connected but video and audio are sometimes
interrupted or not produced
Cause
Solution
Press the OUT P. button and / button so that HDMI
The video or audio of the
output connected with that TV is not selected. Refer to
receiver is interrupted by
"Switching the HDMI output" in the CD-ROM's operating
the TV on standby.
instructions for details.
The power suddenly turns off and the WIRELESS indicator flashes
Cause
Solution
Twist the conductive wire of the speaker cord once again, and
The core wire of the
connect it so that it will not stick out from the speaker terminal
speaker cord is touching
on the amplifier or speaker side.
the rear panel, or touching
other core wires, and the
protection circuit is active.
"Pioneer" is a trademark of Pioneer Corporation, and is used under license.
© 2015 Onkyo & Pioneer Corporation.
All rights reserved.
11
Publicité
