Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
RAS - SGS
2.9
Troubleshooting
Observe the safety instructions and maintenance instructions!
Problem
A
Screws do not unscrew
B
Square bar does not
retain the socket span-
ner
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
If necessary, contact our service staff, see last page.
2.10 REACh
REACh is a European Chemical Directive that
came into effect in 2007. As "downstream
users" and product manufacturers, we are
aware of our duty to provide our customers
with information. We have set up the follow-
II /10
Cause
Socket spanner worn
Air regulation adjusted
incorrectly
Working pressure (flow pres-
sure) too low
Compressor output too small
Hose diameter too small
Socket spanner worn
Retaining ring (item 06) /
Retaining ball (item 07) faulty
or missing
Square bar on the drive shaft
(item 05) worn
ing website to keep you updated with all the
latest news and provide you with information
on all the materials used in our existing prod-
ucts:
www.schneider-airsystems.com/reach
Remedy
X
Replace the socket spanner
X
Correct air
*
regulation
X
Increase working pressure
(flow
pressure)
maximum working pressure
X
Use different output
*
rating
X
Use correct hose diameter
X
Replace the socket spanner
X
Contact
Schneider
tems or your local service
partner
X
Contact
Schneider
tems or your local service
partner.
Observe
*
*
Airsys-
Airsys-
Publicité
Chapitres
Table des Matières
