Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.5
Maintenance
Impact wrench/
Ratchet screwdriver Drive motor lubri-
cation:
L Regular lubrication is required!
X
Apply oil via a maintenance unit with a mist
oiler.
X
Without mist oiler: oil daily by hand via the
plug nipple (item 01).
X
For long breaks in operation, also oil via
plug nipple (item 01) using special oil for
compressed air tools.
Impact wrench
Lubricate the impact mechanism ap-
prox. every 48 working hours:
X
If available:
apply grease via grease nipple (item 10)
approx. every 48 working hours.
Impact wrench
Impact mechanism lubrication
2-3 times a year with oil / grease:
1. If fitted:
Loosen the oil filler screw (item 09).
2. Fill with approx. 5-10 drops of oil.
3. Tighten the oil filler screw.
Alternatively:
1. Loosen the screws (item 13) and open
the
housing (item 08)
Fig. 4a.
2. Remove
the
(Fig. 4b).
3. Lubricate the impact mechanism with oil
/ grease (Fig. 4c).
4. Fit the impact mechanism in reverse or-
der.
Close the housing (item 08) and tighten
the screws (item 13).
as
shown
impact
mechanism
Ratchet
screwdriver
times a year with oil:
1. If fitted:
Lift the rubber protection (item 12).
2. Lubricate the drive bush, drive shaft and
ratchet drive housing through the re-
cesses in the front of the machine or the
via the switch-over button (item 04) as
shown in Fig. 5a.
2.6
Decommissioning
Storage: Clean, dry, dust-free, not below
5° C.
Disposal: Dispose of the packaging / device
/ materials used according to applicable legal
regulations.
2.7
Spare parts service
Visit
our
website
tems.com/td/ for the latest version of all ex-
ploded drawings and spare parts lists for our
products. If you have any special questions,
please consult the Schneider Airsystems Ser-
vice centre in your country (addresses in the
service appendix) or your local dealer.
2.8
Warranty conditions
Basis for warranty claims: complete unit
in original condition/proof of purchase.
According to legal provisions, you re-
ceive the following warranty against
in
material and manufacturing defects:
private use only: 2 years,
commercial use: 1 year.
Excluded from warranty claims: Wear or
expendable parts, improper use, overloading
/ incorrect pressure, manipulation / inappro-
priate use, inadequate / incorrect / lack of
maintenance or lubrication, bumps / im-
pacts, dust / dirt accumulation, unauthorised
/ incorrect working procedures, incorrect
power supply, impure / insufficiently filtered
compressed air, failure to read the instruc-
tion manual, incorrect operating resources /
materials.
RAS - SGS
lubrication
2-3
www.schneider-airsys-
II /9
GB
Publicité
Chapitres
Table des Matières
