Beko WMB 81243 LBB Manuel D'utilisation page 15

the end of the hose. When the container is full,
block the inlet of the hose by replacing the plug.
After the container is emptied, repeat the above
procedure to drain the water in the machine
completely. When draining of water is finished,
close the end by the plug again and fix the hose in
its place. Turn the pump filter to take it out.
Discharging the water when the product does not
have an emergency draining hose:
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill the
flowing water into the container you have placed
in front of the filter. Always keep a piece of cloth
handy to absorb any spilled water. When the
water inside the machine is finished, take out the
filter completely by turning it. Clean any residues
inside the filter as well as fibers, if any, around the
pump impeller region. Install the filter.
If your product has a water jet feature, be
A
sure to fit the filter into its housing in the
pump. Never force the filter while installing it
into its housing. Seat the filter into its place
completely. Otherwise, water may leak from
the filter cap.
If the filter cap is composed of two pieces, close
the filter cap by pressing on the tab. If it is one
piece, seat the tabs in the lower part into their
places first, and then press the upper part to
close.
15
EN