Bestron ABP600 Mode D'emploi page 24

OPERATION - General
The grill is only intended for domestic use,
not for professional use.
1. Handle
2. Grill plate
3. Socket
4. Thermostat dial
5. Indicator light, temperature
6. Removable thermostat
7. Power cord with plug
8. Non-slip feet
OPERATION - Before first use
1. Remove the grill from the packaging, and remove all packaging materials.
2. Clean the grill plate before using the appliance for the first time (see 'Cleaning and maintenance').
WARNING:
• The appliance may emit a little smoke and a characteristic smell when you switch it on for the first time.
This is normal, and will soon stop. Make sure the appliance has sufficient ventilation.
• Keep house birds away from the appliance when it is in use; fumes released from the non-stick coating
when the grill plate is hot can cause stress to birds.
• Do not touch the appliance if it falls into water. Remove the plug from the wall socket immediately. Do
not use the device again.
OPERATION - Preheating
1. Put the appliance on a level and heat-
resistant surface.
2. Insert the thermostat completely into
the connection socket of the grill plate.
Only the supplied cord with thermostat
may be used.
3. Put the plug in the wall socket.
4. Adjust the thermostat dial to the
required temperature
through 5). The indicator light on the
thermostat will illuminate to show that
the heating element has been switched
on.
Position Temperature (°C)
1 approx. 160°C
2 approx. 180°C
3 approx. 200°C
4 approx. 220°C
5 approx. 240°C
5. After waiting a few minutes check whether the indicator light is extinguished. Once the indicator light has
extinguished the appliance has reached the required temperature, and is ready for use.
WARNING:
• Only the supplied cable with thermostat may be used.
• During use the heating element will switch on and off to keep the temperature of the grill plate constant.
Consequently the indicator light will also occasionally be illuminated.
1.
(position 1
24
2.
8.
8.
5
EN
3. 1. 4. 6.
5.
7.