Danby DKC146SLDB Guide D'utilisation Et D'entretien page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operating Instructions
CHANGING THE
REVERSIBLE DOOR
5
Remove the screw from the side of
the Larder Fridge where the
bracket is to be re-fitted.
This Beer Dispenser has a door that can be set to open from the left or
right side. The unit is delivered to you with the door opening from the left
side. To reverse the opening direction, please follow the instructions
below.
To avoid personal injury to yourself and/or property, we
ecommend that someone assist you during the door reversal
process.
1
Undo the three screws in each
bracket using the Phillips
screwdriver.
3
Slide the Larder Fridge door down
about 15cm (6'') and off the top
hinge pin and lift away from the
freezer.
6
Slide the Larder Fridge door back
on to the top hinge, making sure it's
the right way up. Screw the bottom
hinge into place on the new side.
13
CAUTION
2
Remove the screws and bracket.
Place to one side.
Using the flat bladed screw driver
remove the pin from the top bracket.
Replace it in the hinge bracket on
the opposite side.
7
Check that the door is aligned
horizontally and vertically and
that the seals are closed on all
sides before finally tightening
the bottom hinge. Re-adjust
the leveling feet.
4

Publicité

Table des Matières
loading

Table des Matières