Greencut GGT650X Série Manuel D'utilisation page 69

INSTALLATION OF THE MULTITHREADED CARRIAGE
1. Place the inner bracket on the shaft and rotate it until the holes in the shaft and bracket
match. When they match, fix them with the aid of the enclosed L-shaped wrench (1).
2. Place the lower part of the reel on the inner support located on the head shaft.
3. Place the nut and tighten counterclockwise.
4. Place the top of the reel on the axle and turn counterclockwise.
MULTITHREADED REEL LOADING
1. With the Allen wrench, loosen the locking screw (A) (counterclockwise) sufficiently so that the cutting lines
can be removed or inserted through the cutting head.
2. Insert 2 nylon threads (B) approximately 350 mm (14") long through the cutting head, so that the length of
the thread on each side of the cutting head is the same.
3. Tighten the lawn mower head firmly and then, with the help of the Allen wrench, tighten the fixing screw
(A) sufficiently (clockwise) so that the nylon threads are securely fastened.
USE OF MULTITHREADED REEL
• Use nylon thread to cut grass, grass, weeds and small woody plants.
A
69
1
B
EN