Elica Aspire Leone Série Guide D'utilisation, D'entretien Et D'installation page 8

Install Range Hood
1. Using 2 or more people, hang the range hood on the the wall
by placing the slotted holes in the range hood back over the 2
screws mounted to the wood support mounted to the wall.
A
A. Installation screws (2 - 5 x 45 mm)
B. Mounting holes
C. Lower installation screws (2 - 5 x 45 mm)
2. Push the range hood up into the narrow slots, align the bottom of
the hood to the horizontal line, level the hood, and tighten the 2
mounting screws.
3. Mark 2 lower mounting hole locations. Drill
holes are located into wood. If holes are not located into wood,
remove the hood and drill two
mm wall anchors. Remount the hood, level, and tighten the upper
screws. Install 2 - 5 x 45 mm screws and tighten (C)..
4. Connect vent system to hood. Seal all joints with clamps.
5. If your installation uses the optional duct cover, mount it to
the top of the range hood following the instructions supplied
with the duct cover.
B
C
⁄ " pilot holes if the
1
8
⁄ " pilot holes and insert 10 x 50
3
8
Mounting the duct cover
1. Position the duct cover over the mounted hood.
2. Position the top of the duct over the duct mounting bracket.
3. Secure the top of the duct with 2 - 4.2 x 8 mm assembly screws
provided.
4. Secure the lower duct cover to the range hood canopy using
2 - 4.2 x 8 mm screws.
8