Operation; Switching On The Air Cleaner; Automatic Function; Fan Speed - Beurer LR 300 Mode D'emploi

6. Operation

6.1 Switching on the air cleaner

1. Always follow the instructions in chapter "5 Initial use".
2. Insert the mains plug into the socket. Ensure that the cable does not pose a trip hazard.
3. Press the ON/OFF button (
Note
When the air cleaner is used for the first time it is set to the middle fan speed.

6.2 Automatic function

The air cleaner has an automatic function. When the automatic function is switched on, the fan speed
automatically adapts to the ambient air quality. This means that, the poorer the quality of the ambient air,
the higher the fan speed automatically set by the air cleaner.
1. To switch on the automatic function, press the AUTO button while the air cleaner is switched on
( ). As soon as the automatic function is active, a light goes on above the AUTO button.
2. Press the AUTO button (
goes out.
Note
If the light above the AUTO button is flashing, you must replace the filter. To do this, follow the instructions
in the "Filter change" section.

6.3 Fan speed

The air cleaner has three fan speeds:
• To switch between the individual fan speeds, press the fan speed button
set lights up on the control panel.

6.4 UV-C light

The UV-C light eliminates germs contained in the air. Here the UV-C light activates titanium oxides that break
down the foul-smelling odour molecules (caused by tobacco smoke, cooking smells or animals).
1. To switch on the UV-C light , press the UV-C button on the air cleaner while it is switched on (
as the UV-C light is active, a light goes on above the UV-C button.
2. Press the UV-C button (

6.5 Timer function

The air cleaner features a timer function that you can use to determine the number of hours the air cleaner
should run for before it automatically switches itself off. The air cleaner has three timer periods: 2H (two hours),
4H (four hours) and 8H (eight hours).
• To switch between the individual timer periods, press the TIMER button (
currently set lights up on the control panel. The air cleaner will now automatically switch off after the set
number of hours has passed.
• To switch off the timer, repeatedly press the TIMER button (
out. The air cleaner now cleans continuously.
) to switch on the air cleaner.
) again to switch off the automatic function. The light above the AUTO button
(low),
) again to switch off the UV-C light. The light above the UV-C button goes out.
(medium) and (high).
), until the light above the TIMER button goes
17
. The fan speed that is currently
) The TIMER period that is
). As soon