Yamaha YST-SW45 Mode D'emploi page 8

Masquer les pouces Voir aussi pour YST-SW45:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONNECTING TO LINE OUTPUT (PIN JACK) TERMINALS OF THE AMPLIFIER
• Connect the main speakers to the speaker output terminals of the amplifier.
• Amplifier line output terminals are generally labeled PRE OUT or SUBWOOFER OUT.
• To connect with a YAMAHA DSP amplifier, connect the SUBWOOFER (or LOW PASS etc.) terminal on the rear of the DSP
amplifier to either the left (L) or right (R) INPUT 2 terminal.
Using one unit
Left speaker
Amplifier
Using two units
Left speaker
This unit
OUTPUT
INPUT2
AUTO
TO SPEAKERS
STANDBY
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
POWER
ON
OFF
Notes on the above connections
• When connected to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT terminals on
the rear panel of the subwoofer. If connected, they will not produce sound.
• When connecting this unit to a monaural line output terminal of the amplifier, connect to either the left or right INPUT 2 terminal.
• For using a power amplifier and a preamplifier, the preamplifier must have two sets of PRE OUT terminals. If your preamplifier
has only one set of PRE OUT, connect this unit to the speaker terminals. (See page 6.)
8
This unit
OUTPUT
TO SPEAKERS
OUTPUT
INPUT2
AUTO
STANDBY
TO SPEAKERS
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
FROM AMPLIFIER
POWER
INPUT1
ON
OFF
To AC outlet
OUTPUT
INPUT2
AUTO
STANDBY
TO SPEAKERS
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
This unit
OUTPUT
INPUT2
AUTO
STANDBY
TO SPEAKERS
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
POWER
ON
OFF
To AC outlet
To AC outlet
INPUT2
AUTO
STANDBY
LOW HIGH
OFF
‹YAMAHA DSP amplifier›
SUBWOOFER
‹Amplifier›
PRE OUT
OUTPUT
INPUT2
AUTO
STANDBY
TO SPEAKERS
LOW HIGH
OFF
FROM AMPLIFIER
INPUT1
Amplifier
Right speaker
Pin plug
cords
Right speaker
Pin plug
cords

Publicité

Chapitres

Table des Matières
loading

Table des Matières